- Type
- Boiler flue
- Location
- Nottingham, East Midlands
- Status
- Complete
- System
- Fan dilution with plume filter
The job
A fan dilution flue with a plume filter.
We designed, supplied and installed a fan dilution flue system at a government office in Nottingham.
Two boilers and a water heater connect with Ø150 twin wall primaries into a Ø350 dilution header, about 2.5 metres above the plant room floor. The header runs about 10 metres with two bends.
A bifurcated fan with attenuators pushes the diluted flue gas out through a plume filter at least 2 metres above ground, with a pressure switch to prove the fan is running.
Ø350
dilution header
10m
approximate horizontal run
On site.
Site photographs. Tap a photo to see it larger.
Scope
What we delivered.
- Flue dilution design
- Ø150 twin wall primaries into a Ø350 header
- Strut and drop rod supports
- Plume filter discharge
- Fan, pressure switch and attenuators
Project details
- Boiler flue
- East Midlands
- Design, supply and install
Got a job like this?
Price normally within 24 hours of drawings or survey information.